Add flag/option to make the plots adjusted/dynamic

[manuelrn]

Hello,

The new enhancement to generate plots for other levels and not only L1 is much appreciated.
Thank you @bbeny123 and @quietvoid

I was wondering if it would be possible to add to the plot command a flag or option to make the values on the left side (the plot height) adjust/shrink/adapt to the values contained in the RPU.

That is, that the plot range is not always 0-4096 fixed but that it adjusts/adapts to the minimum and maximum value of the content (or 0-10000 in case of L1 plot, although personally I see L1 always fine so I don't see the need to adjust this plot).


I comment this because there are many metadata that often are not so wide and do not cover such a wide range of values, but the values move in a small range and then the plot looks very bad because everything is very small and reduced and you can hardly see anything.

This problem does not usually occur with L1 plots, as I would say that they usually look and feel good, display and appreciate the values well.

Here are a couple of examples:

And those same previous plots generated for example with the DoVi_Scripts tool of R3S3t9999 are seen and appreciated much better since it is not fixed but adapts to the minimum and maximum value of the content:

I would even say that this last plot also looks very bad in the DoVi_Scripts tool, it would be ideal that the range of the plot was smaller and looked wider. But still at least it looks better than in the dovi_tool plot.

Thanks and regards!

[quietvoid]

I was worried about this because the implementation uses static keypoints.
Didn't spend much time trying to fix it but it should be possible.

[manuelrn]

I was worried about this because the implementation uses static keypoints. Didn't spend much time trying to fix it but it should be possible.

There is no hurry, if you can implement it someday it would be appreciated.

By the way, I think the ideal would be to implement an flag or option to enable or disable it as needed. That is to say, make it optional and this way you can choose static keypoints or dynamic keypoints.

I do not mean that dynamic keypoints should be optional and static keypoints should be the default option, I simply mean that there is a configurable option and there is the possibility of having both (that is to say, the static keypoints option is not lost when implementing dynamic keypoints). The default option to be used is left to your choice, I guess the ideal would be to keep the default as it has always been (static keypoints) to maintain the same behavior it has always had.