v106

New features

• settings page, accessible by long-press on the BPM field
• sync setting now migrated to settings page
• pulse width control for each output on settings page

Internal changes

• better support for flash chips
• use more of flash chip
• settings structure made bigger to support pulse width and upcoming features
• older settings migrated on first start up
• measure boundaries now triggered from the sequence timer (freeing up measure timer for future features)
• flash erase and test feature on config screen (warning: will wipe all your settings!)

To load this release on a unit

1. Make sure Pulsar Buddy is powered normally via its 12V jack... it won't power from USB.Connect
2. Connect to your computer via USB.
3. Press the reset button on the Pulsar Buddy twice, quickly. This button is on the display board, in the bottom right, and labeled "Reset". Because it is under the acrylic window, you'll need to use something to get at it. Don't use something metal - I use a credit card.
4. In a few seconds, a USB disk called FEATHERBOOT will mount on your computer.
5. Simply drag the pulsar-buddy-v106.uf2 file onto that drive. It will copy over, and the disk will automatically disconnect. Your computer will probably alert you about this, just close the alert and ignore it.
6. Done! In a second or so the Pulsar Buddy will reboot and you'll be upgraded.