Gpredict - Automate Recording in SDR++?

[AlexLandherr]

Since I've now learned to not use Doppler corrections for APT I have a follow-up question based on that:

Can Gpredict be configured to tell SDR++ to jump to the correct frequency (137.62 MHz, 137.9125 MHz or 137.1 MHz) without Doppler corrections when the corresponding satellite gets to a set elevation above the horizon, start a recording of the received signal and stop it when the satellite gets below said elevation?

E.g. I could perhaps set it up so all passes of a given satellite are recorded within a given time frame?

This seems doable but I'm not sure how it would be done.